If still open, click Apply and OK as appropriate to close N1MM Configurer and PowerSDR Setup windows.Now verify communication between Logger and PowerSDR by performing the following test: After clicking the Set button and configure the following com port parameters:Ĭlick on OK when complete.Setup the com port settings for the Kenwood radio
In the Logger menu bar navigate to Config -> Configure Ports, Telnet Address, Other and perform the following:.Setup N1MM Logger's end of the CAT channel In the ID as: control, select PowerSDR.In the CAT Control panel, check the Enable CAT box.In the PTT Control Panel, select Port COM6 and l eave the RTS and DTR check boxes blank.In the PowerSDR menu bar, navigate to PowerSDR Setup -> CAT Control and perform the following:.Setup PowerSDR's end of the PTT Serial port connection. Any other valid vCom pair may be substituted. For this example PowerSDR uses COM6 and N1MM uses COM7 for the virtual port pair.
Using the vCom Configurator, establish a virtual com port pair to serve as the PTT and CAT virtual serial port between N1MM and PowerSDR It works on a Pentium 3D PC with 1Gbyte of RAM and Windows XP Professional box. This procedure has only been tested with N1MM Logger v7.0.0, PowerSDR v1.10.1 and N8VB vCom v1.0.0.4.
#N1MM LOGGER CONTEST SETUP HOW TO#
How to Setup the N1MM Logger v7.0.0 with PowerSDR 1.x